Pneumatic tools maintenance
In order to pneumatic tools to prolong life, a better play on the use of performance, the company of pneumatic tool maintenance program worked secondary, tertiary level, points. Maintain customer use 1 refers to the process of self maintenance, Secondary maintenance refers to products to customers will be stationed in the pit of local companies, the maintenance engineers of maintenance, 3 maintain refers to secondary maintenance products to company, specialized diagnosis by the engineer, testing and preventive measures.
Level maintenance
1, before the shift to check all joints, leak if trachea should change in time.
2 after the shift, from air piping work should be plucked (wind can rotate open arms oil screw press machine, oil) to head into 3-5 cs. C, special pneumatic JieQi bottom spin speed pneumatic, 3-4 seconds for Martha group fully lubrication.
Before long, if required 7-8C. C pneumatic tools, pneumatic rotating speed for 3-4 minutes for motor sufficient lubrication.
4, after the end of each work of tools to loose easily, not zero check to loose parts are strong.
5 every half a month will impact on the front cover and residual butter clean, daub appropriate butter, lock the front cover, JieQi low starting 20-30 seconds, let the butter and the impact frame group lubricating impact of wear parts inspection.
6, air compressor every two days to put a water.
7 and in the process of clean and maintenance tools, presenting impurities entered in parts of cleave wear, reduce product service life.
Secondary maintenance
In return, the product first appearance check if there is no lack of, such as x-rays parts according to product testing lack test and work instruction in test report.
According to the test results, insufficient points for performance, such as to change troubleshooting wear parts, maintenance, cleaning so desperately parts, components, lubrication Martha lubrication impact, etc.
3 and maintenance of the same products in accordance with the product testing work instruction detection, will meet the footbridge tool product and replacement of parts, and enclose our return maintenance report.
4 and maintenance problems or not more products to maintain, and three companies attach primary repair material.
3 maintain
1 and 2 of the products to maintain cannot complete product engineer, the product engineer check initial maintenance material, use the equipment resources within the company and causes of abnormal report.
2, according to research result corrective and preventive actions drag sheet, within the company network monitoring departments published and the detailed rules for the implementation of the concrete, such things to happen again.
